Control Panel And Features - Kenmore 110.2233 Série Guide D'utilisation Et D'entretien

1
1
SOIL LEVEL
Select the most suitable setting for your load. For heavily
soiled and sturdy fabrics, select Heavy Soil Level for more
wash time, if needed. For lightly soiled and delicate fabrics,
select Extra Light Soil Level for less wash time, if needed.
Lighter soil level setting will help reduce tangling and
wrinkling.
WASH TEMP
2
Wash Temp senses and maintains uniform water temperatures
by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric and
soils being washed. For best results and following the garment
label instructions, use the warmest wash water safe for your
fabric.
• On some models and cycles, warm and hot water may be
cooler than your previous washer.
• Even in a cold and cool water wash, some warm
water may be added to the washer to maintain
a minimum temperature. All rinses are cold.
3
RINSE
This option is used to add additional rinse cycles.
4
WASH CYCLE KNOB
Use the Wash Cycle knob to select cycles on your washer.
See "Cycle Guide" for detailed descriptions of cycles.
5 START/PAUSE/Unlock Lid button
Press to start the selected cycle; press again to pause the
cycle and unlock the lid.
NOTE: If the washer is spinning, it may take several minutes to
unlock the lid. Press and hold for 3 seconds to cancel a cycle.
4

CONTROL PANEL AND FEATURES

2 3
Not all features and options are available on all models.
Appearance may vary.
CYCLE STATUS LIGHTS INDICATOR
6
The Cycle Status Lights show the progress of a cycle. At each
stage of the process, you may notice sounds or pauses that
are different from traditional washers.
SENSING
When the Start/Pause button is pressed, the washer will fill
and begin sensing to determine the load size.
Once sensing is complete, the washer will fill to the detect-
ed load size and then begin the wash phase of the cycle.
NOTE: Sensing fill and agitation phases will be paused by
opening the unlocked lid. Close the lid to resume the cycle.
If the lid is left open for more than 10 minutes the washer
will cancel the cycle and pump out the water. The lid will
lock after the wash phase to begin the initial spin out and
remain locked for the remainder of the cycle.
WASH
You will hear the motor and agitator moving the load.
During the first stage of the sensing/wash cycle, water will
partially fill the washer and then begin to move the load. It
is normal to have the sensing light on during this stage. You
will hear the agitator rotate, followed by a several second
pause. This process will repeat for several minutes, allowing
the entire load to become saturated. The lower water
level combined with HE detergent at this stage allows for
concentrated cleaning. Concentrated cleaning delivers the
detergent directly to the soils. It is normal for the load to
be above the water line during this stage. At the beginning
of the second stage, the washer will add water to the
correct level based on the load size. You will hear the
agitator move quicker during this stage of the wash cycle.
The motor sounds may change at different stages in the
wash cycle.
4
6 5