EMAK 91 Manuel D'utilisation page 80

3.3 FITTING THE SEAT
Mount the seat (1) on the plate (2) using
the screws (3).
2
2
3 3
3 3
3.4 MOUNTING THE FRONT BUMPER
(if provided)
Mount the front bumper (1) on the bottom
of the frame (2) using the four screws (3).
1
3.5 ASSEMBLY AND CONNECTING
THE BATTERY
1
EN 10
1
1
2
1
3
3
2
3
4
5
3
2
3
To access the battery (1) , remove the
inspection hatch (2), which is fixed with a
latch (3).
First connect the red wire (4) to the posi-
tive pole (+) and then the black wire (5)
to the negative pole (–), using the screws
supplied as shown.
4
5
Apply silicone grease to the terminals and
check that the protective cap for the red
wire (4) is in place.
Reassemble the inspection hatch (2),
fixing it in place with the latch (3).
IMPORTANT
battery according to the instructions in
the battery's manual.
IMPORTANT
device in the electronic circuit board
from cutting in, never start the engine
until the battery is fully charged!
1
2
1
Always fully charge the
To prevent the safety