Kroll W 12 VA Mode D'emploi page 16

W 12 VA
Step 1
Mount three standing
hooks on the round
bottom plate as shown in
the figure;
Fix the hook on the
round bottom plate with
a bolt M8×15L.
Step 4
4-1/4-2: Connect the rubber hose
to the fixed gas-guiding parts of
the burner with sealants and
tighten them;
4-3 Insert the rubber hose into the
bracket;
4-4 Place the burner vertically
and with a bracket and connect it
with a bolt 4×M4×10L.
11. Mounting instructions
Step 2
Place the post onto the top of
the post bracket,
Use M6×35L bolts through
each posthole to connect the
post brackets and tighten them.
When storing the heater
Unscrew the bracket bolts;
Turn the bracket through the
posthole and
backwards.
When being put into the
operation again:
Turn and heighten the bracket;
Screw the bolts onto the bracket.
Step 5
Check the vertical assembly is
carried out with a bracket as
shown in the figure;
Check all the bolts and nuts
have been fastened;
Mount three flat nuts upwards
on the bolt abutting against the
reflector (MB threads, one
piece /time).
Place the hood onto the bracket.
press it
Place the reflector over 3
securing bolts on the top
of the burner;
Fit the washers into each
reflector support bolts
and secure with wing
nuts
Step 3
Step 6
16