Installation - ETNA T7400 Notice D'utilisation

Installation of the oven
- Insert the oven partially into the cavity.
- Connect to the mains supply. Insert the power
plug of the hob into the oven connector.
- Mount the control knobs. Insert the spring
between the knob and the rosette.
Please note! Mount the rosette in the right
position (see illustration). Attach the knob with
spring and rosette to the opening at the front
of the oven (1).
Right
Wrong
3
1
Please note! Make sure the knob is in the
'0'-position.
- Slide the telescopic slide guides of the hob
onto the shafts of the control knobs at the rear
end of the oven (2).
Please note! Fasten the telescopic slide
guides to the shafts of the control knobs with
the corresponding linchpins (3).
- Check the functionality of the control panel.
Please note! Check the locked position of
the control knobs (press first, then turn). Push
the oven into the kitchen cupboard entirely and
secure the oven with the 4 screws supplied.
- Check whether the oven casing does not touch
the inner surface of the cabinet. Make sure
there is a space of at least 2 mm between
the oven casing and the inner surface of the
cabinet.
2