EUROM E-Convect LCD in control Manuel D'utilisation page 31

 Secure both screws and thereby clamp the panel in the feet.
 Your E-convect LCD in control is ready to use.
Use and working
 Make sure the heater is not damaged.
 Insert the plug in the socket
 Turn the switch (6) on (I): the light will turn on and the display flashes fleetingly
on the last set temperature and then displays the room temperature.
 If you press the up/down key (7&8), the temperature setting will flash 5x on the
display. You can adjust the temperature setting by pressing the up/down key
while it is flashing. With each key press, the temperature will be increased (▲)
or decreased (▼) by one degree. If you set the temperature higher than the room
temperature, the heater will operate until the set temperature is reached.
 The device will retain the temperature setting by switching itself on and off
automatically.
 To switch the E-convect LCD in control off, you turn the switch off (O); the light
and the display goes out.
Remote Control
The E-Convect LCD in control can also be operated with the included remote
control. It also includes a timer function.
 Push the plug in the wall socket.
 Switch the switch (6) on (I): the light comes on and the
display flashes fleetingly on the last set temperature and
then indicates the room temperature. You can now use
the remote control.
 To set the temperature, press on the 'heating' button.
The – (down) and + (up) buttons now work as the ▼
and ▲ keys on the device.
 To set the timer, (while the device is working) press on
the 'Timer' key, then you set the hours with the + and
– buttons (max. 24): the display fleetingly shows the set
number of hours and will repeat this intermittently. The
heater switches itself off after the selected number of
hours.
 You can set the device on standby at any stage by using the 'power' button: the
display switches off, the switch globe continues burning. You can now also switch
on the device with the power button.
 To switch off the E-convect LCD in control, switch off the (O) switch; the globe
and the display switches off. Remove the plug from the power point.
Remove the plug from the socket.
31