EUROM E-Convect LCD in control Manuel D'utilisation page 26

E-convect lcd in control
Masquer les pouces Voir aussi pour E-Convect LCD in control:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

It must be resistant to temperatures of at least 125°C without
burning, melting, deforming or bursting into flames. Check regularly
to ensure that the surface is not overheating; this could be
dangerous!
8. Never place the device on surfaces such as beds or deep-pile carpet
as openings could be blocked.
9. Do not place the device near an open window as rain could blow in;
do not place on wet surfaces and avoid any liquids being spilt
nearby. Do not place the device behind a door or along a walking
route to avoid accidental trips.
10. Do not place the device near, under or facing an electrical socket
and not in the vicinity of an open fire or heat source.
11. Do not use the device nearby or facing furniture, curtains, paper,
clothing, bedding or other flammable materials. Keep at least 1
metre from device!
12. Do not use the heater outdoors or in areas that are smaller than
10m³.
13. The device contains hot and/or glowing and sparking components.
Do not, therefore, use where fuels, paint, flammable fluids and/or
gases are stored. Do not use the device in an environment that
poses a fire risk, e.g. near gas tanks, gas pipes or aerosols. This is
an explosion and fire risk!
Warnings – use
1. Do not use additions/accessories on the device that have not been
supplied or approved by the manufacturer.
2. Only use the device for its intended purpose and in the manner set
out in this instruction leaflet.
3. Some parts of this device will get very hot and could cause
burns. You must pay particular attention to children,
vulnerable persons and pets that are present near the
device. Never leave them alone with a working device.
4. Never cover or block the device; it will overheat and this could lead
to a fire risk. Never hang or place objects such as clothing,
blankets, cushions, paper, etc. on the device. The minimum
distance of 1 metre between the device and flammable materials
must always be applied. Ventilation openings should never be
blocked as this may pose a fire risk. Never use the device to dry
26

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

351538

Table des Matières