EUROM E-Convect LCD in control Manuel D'utilisation page 30

Description, composition and installation
1. Heatpanel
2. Control panel
3. Feet (2x)
Control panel:
4. Reception point remote control
What is unique about the E-convect LCD in control, is that it can be painted. You
can paint the E-convect LCD in control in any colour you wish, with any water
resistant paint. Do not paint the control panel with the switch and remove the plug
from the socket before you start painting. Allow the panel to dry before using it
again!
After removing packaging, check the appliance for damage or other signs that could
indicate a fault/defect/malfunction. In case of doubt, do not use the appliance, but
contact your vendor for inspection or replacement. Keep all the packaging material
out of reach of children.
Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
Attachment of the feet
Secure the feet supplied to the underside of the
radiator (see diagram):
 Place both feet on the ground, ± 50 cm. apart,
screws to the back
 Slide the heating panel into the slot of the feet, so
the panel sticks out ± 5 cm on each side. The
switch is at the top right rear (see fig. on front of
this booklet).
5. Display
6. ON/OFF switch & pilot light
7. Up key
8. Down key
9. Timer bulb
30