Control Of Functions; Ash Removal - Jøtul F 602 Manuel D'installation Et D'utilisation

ENGLISH

3.5 Control of functions

When the product is set up, always check the control functions.
These shall move easily and function satisfactorily.
Jøtul F 602 is equipped with the following controls:
Air vent, fi g. 4 D
Left position: closed
Right position: open

3.6 Ash removal

• Use a scoop or similar to remove the ash through the door.
• Always leave some ash as a protective layer on the bottom
of the fi replace.
• Ash must be placed in a metal container with a sealed lid.
Also see the description below about how to handle ash: «3.0
Safety precautions».
22
4.0 Service
Warning! Any unauthorised change to the product is illegal.
Only use original spare parts.
4.1 Changing the air chamber
1. Remove both the right and the left burn plate (fi g. 6) as well
as the the insulating sheets situated at the rear of the plates.
2. The steelplate situated underneath the baffle plate
(fi g. 5) is called the air chamber. This is assembled with the
aid of 12 screws. Remove these screws.
3. Gently knock on the air chamber with a hammer to loosen
the cement. Remove the air chamber through the door.
4. Remove all the old cement remaining in the groove. Apply
new cement.
5. Assemble the new air chamber with the aid of new screws.
6. In case of damage, replace the insulating sheets with new
ones. Reassemble the plates.
4.2 Changing the baffl e plate with
the air chamber
1. Remove both the right and the left burn plate (fi g. 6) as well
as the insulating sheets situated at the rear of the plates.
2. Unscrew only the two screws underneath the rear of the
plates. Use a wrench. Gently loosen the baffl e plate with a
hammer.
3. Remove the cooking plate. Unscrew the top plate's 4 screws
from underneath. The top has been cemented and may be
stuck. Knock gently to loosen.
4. Lift the baffl e plate through the top of the stove.
5. Rinse the old cement out from the groove. Apply new
cement.
6. Removing the top plate may somewhat cause both the
front- and the rear plate, as well as the side plates, to loosen.
Disconnect the plates, clean the grooves and apply new
cement before all the plates are being replaced.
7. Assemble the new baffl e plate including the air chamber.
8. Reassemble the top plate.
9. In case of any damage, replace the insulating sheets situated at
the rear of the burnplates with new ones. Reassemble the plates.
4.3 Changing the burn plates/base
plate (Fig. 6)
1. The burnplates and the base plate are loosely assembled.
To remove the burnplates tilt the side burnplates from the
bottom and pull it out through the door.
2. Tilt one of the base plate's two parts in an upward manner
at the front edge. Lift it up and pull it out through the door.
3. To replace the defected parts, repeat the same procedure
in reverse order.
4. If the part should get stuck, use a large screwdriver or similar
to fl ip them loose. Ensure that all the insulating sheets are
undamaged before you reassemble the parts. It may also
become necessary to replace some of the screws and nuts.