Angelo Po 191TPE Manuel D'utilisation Et D'installation page 36

If the problem or fault noticed is not amongst those
listed in the table, consult the "Key to Alarms" table
provided below.
The information provided below s intended to iden-
tify the alarm signals which appear on the display
(E).
Alarm
Err
Er3
IT IT
GB GB
DE DE
FR FR
Er4
ES
ES
English
TABLE OF ALARM INDICATIONS
Fault
Thermocouple TCJ mal-
function
Sudden change in tempe-
rature (thermal shock)
Electronic display circuit
board diagnostics tripped
Electronic circuit board
heat sensor tripped
Cooling fan malfunction
Cooling air duct obstructed
E
Remedy
Check the connection of
the electrical wires
Allow the appliance to cool
and return it to "ON" status.
Replace the electronic
display circuit board
Allow the appliance to cool
and return it to "ON" status.
Check the connection of
the electrical wires
Check the cooling air duct
and clean it if necessary
- 14 -
IDM-39617100600.tif
Notes
Important
Contact the after-sales
service
The appliance switches to
stand-by mode
Important
Contact the after-sales
service
Important
If the problem persists,
call the after-sales
service
The appliance switches to
stand-by mode
Important
Contact the after-sales
service
The appliance switches to
stand-by mode
Important
If the problem persists,
call the after-sales
service
The appliance switches to
stand-by mode