Maintenance - AERMEC EWA-H Manuel De Fonctionnement

MAINTENANCE

Be sure to disconnect the power cord from the wall outlet or turn off the circuit
breaker before performing any maintenance.
CLEANING THE FILTERS
1
2
3
2
1
CLEANING THE UNIT AND THE REMOTE CONTROL
• Wipe them with a soft cloth.
• Do not directly splash or pour water on them, or it can cause electrical shock or
equipment damage.
• Do not use hot water, thinner, abrasive powders or strong solvents.
MAINTENANCE AFTER AIR
CONDITIONER SEASON
1
Operate the unit in the COOL
mode, temperature setting 32°C,
for about half a day to allow the
mechanism to thoroughly dry.
2
Stop the operation and unplug the
unit. Turn off the circuit breaker, if
you have one exclusively for the
air conditioner.
3
Clean the filters, then reinstall
them.
The air filters should be cleaned every two weeks.
1
2
3
3
4
E-15
TURN OFF THE UNIT
REMOVE THE FILTERS
1 Lift the open panel.
2 Push the air filters up slightly to un-
lock them.
3 Pull the air filters down to remove
them.
CLEAN THE FILTERS
Use a vacuum cleaner to remove dust.
If the filters are dirty, wash them with
warm water and a mild detergent. Dry
filters in the shade before reinstalling.
REINSTALL THE FILTERS
1 Reinstall the filters in the original po-
sitions.
2 Close the open panel.
3 Push the arrow-marked points shown
left firmly to lock it in place.
MAINTENANCE BEFORE
AIR CONDITIONER SEASON
1
Make sure that the air filters are
not dirty.
2
Make sure that nothing obstructs
the air inlet or outlet.
3
Check the outdoor mounting rack
periodically for wear and to make
sure it is firmly in place.