Important Maintenance Information; Packing - AERMEC FCZ U Manuel D'utilisation Et D'installation

EN FR

IMPORTANT MAINTENANCE INFORMATION

WARNING: The fancoil is connected to the power supply and
a water circuit. Operations performed by persons without
the required technical skills can lead to personal injury to the
operator or damage to the unit and surrounding objects.
POWER THE FANCOIL WITH SINGLE-PHASE 230 V ONLY
• Use of other power supplies could cause permanent damage to
the fancoil.
NEVER USE THE FANCOIL FOR APPLICATIONS FOR WHICH IT
WAS NOT DESIGNED
• Do not use the fancoil in husbandry applications (e.g. incubation).
AIR THE ROOM
• Periodically air the room in which the fancoil has been installed;
this is particularly important if the room is occupied by many
people, or if gas appliances or sources of odours are present.
CORRECTLY ADJUST THE TEMPERATURE
• Room temperature should be regulated to ensure maximum
comfort to persons present, particularly in the case of the elderly,
infants and invalids. Prevent temperature fluctuations between
indoors and outdoors greater than 44,6 °F during summer.
• Note that very low temperatures during summer will lead to
greater electricity consumption.
ORIENT AIR FLOW CORRECTLY
• Air delivered by the fancoil should not be oriented directly at
people; even if air temperature is greater than room temperature,
it can cause a cold sensation and consequently discomfort.
DO NOT USE HOT WATER
• When cleaning the indoor unit, use rags or soft sponges soaked in
warm water (no higher than 40°C).
• Do not use chemical products or solvents to clean any part of the
fancoil.
• Do not splash water on interior or exterior surfaces of the fancoil;
danger of short circuit.
PERIODICALLY CLEAN THE FILTER
• Frequent cleaning of the filter will ensure more efficient unit
ATTENTION
In the case of installation in very dusty environments, clean the
dust accumulated in the metal clips inserted into the filter guides
with a vacuum cleaner; perform a visual inspection in order to
verify the contact between clips and filter.
Every anomaly must be communicated to the After-sales Service
(See section "Drawings" Figure 1 ").

PACKING

• The units are shipped in cardboard box standard packing and
polystirene shells.
8
operation.
• Check whether the filter requires cleaning; if it is particularly dirty,
clean it more often.
• Clean the filter frequently. Use a vacuum cleaner to remove built
up dust. Avoid water or detergents if possible since they greatly
accelerate loss of the filter's electrostatic charge.
• After cleaning and drying the filter, fit it on the fancoil by following
the removal procedure in reverse order.
SPECIAL CLEANING
• The removable drip tray and fan volute ensure thorough cleaning
of the unit (by specifically trained personnel), (See Fig.6 page 34)
essential for installations in venues subject to crowding or in those
with special hygiene requirements.
DURING UNIT OPERATION
• Always leave the filter on the fancoil during operation (otherwise
dust in the air could soil the surface of the coil).
IT IS NORMAL
• During cooling, water vapour may be present in the air delivery
of the fan coil.
• In the heating function it might be possible to hear a slight
hiss around the fan coil. Sometimes the fan coil might give off
unpleasant smells due to the accumulation of dirt in the air of the
environment (especially if the room is not ventilated regularly,
clean the filter more often).
• During the operation, there could be noises and creaks inside the
device, due to the various heat expansions of the elements (plastic
and metallic), but this does not indicate any malfunctioning and
does not cause damage to the unit unless the maximum input
water temperature is exceeded.
WARNING
• Avoid that the device is used by children or incompetent persons
without appropriate supervision; also note that the unit should
not be used by children as a game.
ATTENTION
Take out the ambient probe, taking care not to wrench out the
cable connected to the control board. Replace the probe and
connect the cable in the same position (See section "Drawings"
Figure 2 ").
IFCZASUALJ 2107 - 4033740_02