Adjusting The Air Flow Direction - AERMEC EWA-H Manuel De Fonctionnement

ADJUSTING THE AIR FLOW DIRECTION

VERTICAL AIR FLOW DIRECTION
Press the SWING button on the re-
mote control once.
• The vertical adjustment louvre will
change its angle continuously.
Press the SWING button again
when the vertical adjustment louvre
is at the desired position.
• The louvre will stop moving within
the range shown in the diagram.
• The adjusted position will be
memorized and will be automati-
cally set to the same position when
operated the next time.
HORIZONTAL AIR FLOW DIRECTION
Hold the horizontal adjustment louvre as shown in the diagram and adjust the air
flow direction.
(EWA070H/EWA090H)
CAUTION
Never attempt to adjust the vertical adjustment louvres manually.
• Manual adjustment of the vertical adjustment louvre can cause the unit to malfunction
when the remote control is used for adjustment.
• When the vertical adjustment louvre is positioned at the lowest position in the COOL or
DRY mode for an extended period of time, condensation may result.
Do not adjust the horizontal adjustment louvre to the extreme left or right in the COOL mode
with the fan speed set to "SOFT (
Condensation may form on the louvres.
Adjustment range
COOL and DRY modes
The adjustment range
is narrower the SWING
range in order to pre-
vent condensation from
dripping.
)" for an extended period of time.
E-9
HEAT mode
The range is wide
and air flow can be
directed toward the
floor.
(EWA120H)