Two Piece-Shaft; Air Filter - Husqvarna 535FBX Manuel D'utilisation

a) Shake or pull the drive shaft out of the drive shaft
sleeve.
2. Lubricate the drive shaft.
3. Push and turn the drive shaft at the same time to put
it back in the drive shaft sleeve. Keep approximately
10 mm / 0.40 in. of the drive shaft outside the edge
of the drive shaft sleeve.
4. Align the hole in the drive shaft sleeve with the knob
on the clutch cover.
5. Push and turn the drive shaft at the same time to
connect it.

Air filter

Remove dust and dirt from the air filter to keep it clean in
order to prevent:
1301 - 004 - 30.01.2021
• Carburettor malfunctions.
• Starting problems.
• Loss of engine power.
• Unnecessary wear to engine parts.
• Too much fuel consumption.
Clean the air filter at an interval of 25 hours, or more
regularly if conditions are unusually dusty.
To clean the air filter
CAUTION: An air filter that is damaged, very
dirty or soaked with fuel must always be
replaced.
If you use an air filter for a long time, it cannot be fully
cleaned. Replace the air filter with a new one at regular
intervals.
1. Move the choke lever up, to close the choke valve.
2. Remove the air filter cover and remove the air filter.
3. Clean the air filter with warm soap water.
4. Replace the air filter if it is too dirty to fully clean it.
Always replace a damaged air filter.
5. Also clean the inner surface of the filter cover. Use
air or a brush.
6. Do a check of the rubber sealing surface. Replace
the filter on the rubber seal if it is damaged.
7. Make sure that the filter is dry before you assemble
it.

Two piece-shaft

Apply grease to the end of the drive shaft after each 30
hours of operation. There is a risk that the drive shaft
ends (splined coupling) on models with two-piece shafts
will seize if they are not lubricated regularly.
23