Husqvarna 535FBX Manuel D'utilisation page 13

3. Adjust the backplate to the correct height. Make sure
that the pin aligns with 1 of the holes on the frame.
To adjust the harness
1. Put on the harness of the product.
2. Tighten the hip strap tightly. Make sure that the hip
strap aligns with the hip.
3. Tighten the chest strap.
4. Adjust the chest strap vertically. Make sure that the
chest strap is tight against your body.
1301 - 004 - 30.01.2021
5. Adjust the shoulder strap until the weight is equal on
your shoulders.
To set the work height
1. Pull out the cord to the necessary work length and
make a knot.
2. Install the knot to the suspension ring on the shaft.
3. To make the cord shorter, pull the cord up by the top
part of the load reducer. The load reducer
automatically winds the cord when the tension
decreases.
A
B
13