Wireless Receiver (Separate) - Winkhaus blueMatic EAV Instructions D'installation, D'utilisation Et D'entretien

Installation, Operating and Maintenance
Instructions blueMatic EAV
CAUTION!
blueMatic EAV must be
operated with 12 V.
12 V = delivery status
Figure 3.5.1-3: Adjustment of the jumper for voltage selection
• The default setting of the jumper is 12 V.
• The wireless receiver can be adjusted from 12 V to 24 V via the jumper.
NOTICE!
Check the proper position of the jumper before starting operation!
3.5.2

Wireless receiver (separate)

Separate wireless receiver for additional applications, such as garage door control
units.
Figure 3.5.2-1: Installing the wireless receiver (dimensions in mm)
Installation sequence
• Remove the cover of the housing.
• Fasten the housing with screws.
• Push in the rubber plug (see Figure 3.5.2-1).
• Insert the circuit board of the remote according to figure 3.5.2-2 and connect it to
the control of the additional application (for example to the garage door control
unit).
Aug. Winkhaus GmbH & Co. KG · Berkeser Str. 6 · D-98617 Meiningen
Subject to technical changes
37
24 V
Print-no. 504 474 4
01/2017
General
information
Important
information
Product
description
Installation
Operation
Programming
Maintenance
and care
Errors
Troubleshooting
Technical
specifications
Accessories
www.winkhaus.de
EN
1
2
3
4
5
6
7
8