Operation; Preparing For Use - Tineco iFloor Série Mode D'emploi

Operation

Preparing for Use

Before first use, please charge the appliance for 3-4 hours (refer to "Charging Instructions" for details).
* Based on results from Tineco lab tests. Lab temperature 39.2°F (4°C) ~ 104°F (40°C). Use directly
when you just need to absorb water; add water/solution when you need to deep clean the floor
(refer to "Filling Clean Water Tank" for details).
<144°
Note:
• Do not vacuum foamed liquid.
• It takes about 5 mins to dry the floor in normal mode/8 mins in Spot mode, depending on cleaning
environment.
• To dry the floor faster and avoid over wetting, please release the trigger after each spray of liquid.
Switch ON to start the appliance.
Press Spot button for spot mode to remove tough spots
and stains with higher speed and stronger spray.
Squeeze the Solution trigger when moving backward to
spray liquid as needed.
* Overlap strokes by one inch to help prevent streaking, it
will pick up dirty water during cleaning.
Do not recline more than 144° to protect against water
leakage.
Place the appliance on the storage tray vertically after use.
9