Operation; Preparing For Use - Tineco FLOOR ONE S3 Serie Mode D'emploi

Operation

Preparing for Use

Before first use, please charge the appliance for 4-5 hours (refer to "Charging Instructions" for details).
* Based on results from Tineco lab tests. Lab temperature 39.2°F (4°C) ~ 104°F (40°C).
Press the button and the appliance will start
in AUTO mode by default. Press it again to turn
off the appliance. Switch between AUTO and
MAX mode by pressing the
Stop Working
The appliance will stop working when put uprightly
and start running again when you recline.
* Do not recline more than 142° to protect
against water leakage.
Note:
• Selecting the appropriate mode depending on the CWT contents is vital for maximum dirt detection
effectiveness.
• Do not vacuum foamed liquid.
• To vacuum water left on the surface, the appliance will switch off in 3 seconds after power off.
button.
Start Again
Tips:
• Solution mode/ Water Only mode:
Appliance starts with Solution mode by
default. Power on while the appliance is
upright, long-press
between the two modes.
• Switch to Water Only mode:
LED Loop: Red → Blue (use water only)
• Switch to Solution mode:
LED Loop: Blue → Red (use cleaning solution)
Place the appliance on the charging base
vertically after use for recharge and storage.
10
for 3s to switch