Assembly; Operation - Tineco iFLOOR 3 Serie Mode D'emploi

16 Deodorizing & Cleaning Solution
17 Cleaning Tool
18 Dry Filter & Holder
19 Accessory Holder
20 Adaptor
21 Charging Base
22 Self-cleaning Icon
23 Brush Roller Tangled Indicator
24 DWT Full or Blocked
25 Battery Indicator
26 CWT Empty
27 MAX Power
Fig.A

ASSEMBLY

How to Assemble/Disassemble
Note:
For water tank and brush assembly, please refer
to "Operation" and "Maintenance".
• To assemble the handle, insert it into the
appliance until you hear a "Click".
Fig.B-1
• In the event that the handle need to be
disassembled, press the spring to release the
handle with a tool (like a screwdriver) and lift
the released handle from the appliance.
Fig.B-2

OPERATION

Preparing for Use
• Before first use, please charge the appliance
for 4-5 hours (refer to "Charging Instructions"
for details).
* Based on results from Tineco lab tests. Lab
temperature 39.2°F (4°C) ~ 104°F (40°C).
1.Press the button and the appliance will
start in ECO mode by default. Press it again to
turn off the appliance. Switch between ECO
and MAX mode by pressing the
Fig.C-1
2.The appliance will stop working when put
uprightly and start running again when you
recline.
* Do not recline more than 142° to protect
against water leakage.
Fig.C-2
3.Place the appliance on the charging base
vertically after use for recharge and storage.
Fig.C-3
Note:
• Do not vacuum foamed liquid.
• To vacuum water left on the surface, the
appliance will switch off in 3 seconds after
power off.
Filling Clean Water Tank
1.Press the Clean Water Tank release button to
remove it from the appliance.
Fig.C-4
2.Open the tank cap, and fill with tap water to
the Max line. When deep cleaning is necessary,
add one bottle cap of solution to the CWT and
tightly close the cap.
Fig.C-5
Note:
Only use water under 140°F/60°C.
DO NOT USE HOT WATER.
3.Place the tank back into the appliance. You
should hear a "Click" if done correctly.
Fig.C-6
Charging Instructions
To charge the appliance, place the appliance on
the charging base and plug the adaptor into a
power outlet.
1.To charge the appliance, connect the external
charging cord to the charging base and plug it
into the wall outlet.
2.To avoid tripping hazards, please place the
appliance on the charging base near a wall
during charging.
Fig.C-7
20
MAX ECO
button.