Technical Instructions For Installation And Regulation; Safety Measures From The Standpoint Of The Fire Protection According To En 061008 Čl. 21 - CombiSteel 7471.1000 Mode D'emploi

TECHNICAL INSTRUCTIONS FOR INSTALLATION AND REGULATION

Important:
The manufacturer does not provide warranty for defects caused by improper use, failure to instructions
contained in the attached instructions for use and mistreatment of the appliances.
Installation, adjustment and repair of appliances for kitchens, as well as their removal because of possible
damage to the gas can be carried out only under a maintenance contract, this contract may be signed with an
authorized dealer, and must be complied with regulations and technical standards and regulations regarding the
installation, power supply, gas connection and health & safety system.
These instructions are intended for the qualified technician who must perform the installation, put it into
operation and test the appliance.
Any activity as settings, placement, rebalancing etc., must be made only when is device disconnected from
electricity. If it is necessary to have the device connected to the electricity you must keep the highest attention
to avoid any injuries.
DEVICE INSTALATION
Installation, setting, rebuilding for another gas type, putting into operation must be done by qualified person
who is competent for this and according to the valid standards. The device can be installed in good ventilated
room. When it is possible place the device under the fume hood to suck off the products of combustion. Air
needy to the burning is 2m/3/h/kW of the performance of the installed device. The device can be installed
separately or in a set with devices of our production. Min. distance 10 cm from other subjects must be kept. It is
also necessary to prevent our product from contact with combustible materials. In this case you must make
corresponding changes to secure heat isolation of combustible parts (for example: place between the device and
combustible material asbestos plate).
SAFETY MEASURES FROM THE STANDPOINT OF THE FIRE PROTECTION
ACCORDING TO EN 061008 ČL. 21

Only adults can operate the device

Device must be safely used in common surroundings according to EN 332000-4-462; EN 332000-4-42.
You must switch the gas device off under the circumstances leading: to the danger of the temporary
rise of the combustion gas or steam or during works when there is a big possibility of rise to the
temporary fire danger or explosion (for example: to stick linoleum, pvc etc.).

Before you start to install the device you must get the license for connection to the gas feeder from the
gasworks

Device must be placed so as to stand or hang on the noncombustible surface which is on each side 10
cm larger than the device. No subjects from combustible materials can be placed directly on the device
or in distance which is shorter than safety distance (the shortest distance is 50 cm in the direction of
the heat emission and 10 cm in other directions).- safety distances from various materials of different
degree of combustion and information about the degree of comb. Of common building materials - see
chart:
www.combisteel.com
5