Instruction For Use - CombiSteel 7471.1000 Mode D'emploi

Chart:
Combustion degree of building materials classified according to the combustion degree of materials and
products (EN 730823)
A noncombustible
B uneasily combustible
C1 hardly combustible
C2 middle combustible
C3 easily combustible
Devices must be installed in a safe way. When installing you must respect corresponding project, safety and
hygienic orders according to:

EN 061008 fi re protection of local devices and sources of heat

EN 332000 (33 2000-4-482; 33 2000-4-42) surrounding for electric devices ČSN EN 1775 Gas supplying

Gas fi ttings in the buildings - the highest operational pressure < 5 bar - operation demands

§ 10 law nr. 185/2001 Sb. about waste
CONNECTION OF THE ELECTRIC CABLE TO THE ELECTRICITY
Installation of electric feeder - This feeder must be separately protected by a safety fuse according to the specific
electric stream which depends on the wattage of the installed device. Check the wattage on the label at the back
of the device. Connect the device directly to the electricity but you must put the switch between the device and
electric net. The switch must be placed in min. distance 3 mm between the particular contacts according to the
standards and loading. The feeder of grounding (yellow-green) cannot be interrupted by this switch. In every
case feeding cable must be placed so that no point of the cable will reach the temperature which is 50°C higher
than the temperature of the surrounding. Before connecting the device check that:
• Safety fuse of the feeder and inner mains can stand the loading of the device (see label of the matrix)
• Mains are equipped with effective grounding according to standards (čsn) and conditions given by law
• Socket or switch of the feed is well accessible from device
We refuse any responsibility in case of not respecting above mentioned rules. Before the first use it is necessary
to remove all the protection foil and to clean the device - see chapter „cleaning and maintenance".
Maintenance: We recommend to have the device checked once a year by the professional service. Only qualified
or competent persons can do interventions in the product.

INSTRUCTION FOR USE

Attention! Before the first use of the device you must remove protection foil from all surfaces and wash the
device with water with detergent. Than splash it with clean water. Use the device under supervision. Never use
the device without oil or if the level of the oil is lower than min. line - danger of fi re. If the oil is dirty or you use
the oil longer time it may cause boiling over.
Do not fry more than 1 kg of food together in one bath. Fill the device with frying oil not higher than the line on
the side. Switch on with main switch (B) turn the knob (E) to required position between 90°C - 180°C. Pilot lamps
(C) and (D) will light. Pilot lamp (C) lights when the device is in electricity and switched on. Pilot lamp (D) lights
when the thermo spirals are on. Pilot lamp (D) goes out when the device reaches required temperature. Switch
the device off by turning the knob (E) into position „0" and switch over the switch (B) into position „0".
granite, sandstone, concretes, bricks, ceramic wall facing tiles, plaster
akumine, heraklite, lihnos, itavere
leafy wood, plywood, sirkoklit, rare paper formica
fi breboards, solodure, cork boards, rubber, floor-coverings
wood-fi breboards, polystyrene, polyurethane, PVC
www.combisteel.com
6