Informations And Equipments Related To Product; Device Description/Explanation; Replacing The Device And Preparing For Start Up; Installation Before Assembling - CombiSteel 7478,0565 Mode D'emploi

The manufacturer reserves the right to make any modification or amendments partially or entirely on any part of machine, if it considers
necessary or beneficial or to be in favor of user or product without any previous notification. Besides, the producer guarantees that the
fundamental functionality and security specifications of the machines should also be kept as required
In the event of any fault, switch off all electric/Water connections then apply to the authorized service staff.
Power cord must be min. H05RN-F type.
Grounding line must be continuously checked.
The oıl level never up to max mark.
Don't use old oil.
You don't use wet potatoes.
We recommend installing the machine under a range hood so that all fumes are removed quickly as possible.
If the appliance is to be installed near the wall etc. This should be non-inflameble meterial or covered with non-inflameble meterial or it
is necesasary to keep machine far at least 100 mm.
7.

INFORMATIONS AND EQUIPMENTS RELATED TO PRODUCT

A. Description Catalogue
B. User/Maintenance/Assembling Manual
Dear Customers, please check the above written auxiliary equipment to be given with the machine on delivery. If you notice any damage or
loss occurred during the transportation then you should request the transporter to issue any written report including the relevant damage or
loss.
8.

DEVICE DESCRIPTION/EXPLANATION

The device have wholly manufactured regarding to hygienic standards.
Outside, inside and all surfaces contacting to the food of the device have been manufactured completely AISI 304 (Cr-Ni 18/10) stainless steel
material.
The legs are in adjustable feature and manufactured by stainless steel material.
For the insulation purposes, glass- wool and stone–wool have been used. Thanks to this application, wasting of
prevent.
Electrical operated devices have been secured completely by means of thermal and electrical relays.
Accesses to control panel, maintenance and checking have been facilitated.
Electrical components and cable are complied with the relevant standards.
9.

REPLACING THE DEVICE AND PREPARING FOR START UP

INSTALLATION BEFORE ASSEMBLING

Open the packing of the device and remove all protective tapes.
Opening the cover of the device, take out the instruction manual and guarantee document.
Place the devices with adjustable legs by adjusting their legs and the device with fixed legs by aligning the ground.
Make the grounding connection thoroughly.
Be sure that the energy supplied.
Authorized and certificated people must make all these connection.
Now, your device is ready for use.
DISCONNECTION : Disconnection of the machine is to do via disconnect all poles (R,S,T,N).

PREPARATION FOR START UP

Assuming that electrical installation connections have already made by competent technicians, the user must implement the following
simple inspections
7/49
energy can be able to