Packing And Device Check; Placement - CombiSteel 7471.1000 Mode D'emploi

PACKING AND DEVICE CHECK

The device leaves our stocks properly packed with appropriate symbols and labels. There are also appropriate
instructions for use. In case the packing shows bad handling or damage, it must be reclaimed at transporter
immediately by writing and signing of a damage protocol.
Important notice:

Only for professional use.

This instructing guide must be read properly and carefully because it contains important information
about.

Safety elements, installation, use

These recommendations refer to this product

This product corresponds with valid standards

This guide must be properly deposited for future use

Keep the children away from manipulation with the product

When selling or moving the product to another place it is necessary to make sure that the staff or the
professional service has got acquainted with control and installation instructions from enclosed guide

Only authorised person can operate the product

It cannot be switched on without supervision

We recommend to have the product checked by professional service min. Once a year

Only original spare parts can be used for repairs

The product cannot be cleaned by the water jet or pressure shower

By damage or break down disconnect all the feeders (water, gas, electricity) and call professional service

Producer refuses any responsibility in case of damages caused by wrong installation, by disobserving of
above mentioned recommendations or by other use etc.

PLACEMENT

The device must be installed in well ventilated room what is necessary for regulation of the function of the device
(technician must go by valid standard (EN....). If the device is situated close to the wall or if it is in contact with
the furniture walls, these walls must resist the temperatures ranging to 90°C. Installation, setting, putting into
operation must be done by qualified person who is competent for this and according to the valid standards.
Wrap up the device and check whether it was not damaged during transport. Settle the device on horizontal
surface (max imbalance 2°).Settle the device under the fume hood to eliminate water steam and bad smell. The
device can be installed separately or in a set with devices of our production. Min. distance 10 cm from other
subjects must be kept. It is also necessary to prevent our product from contact with combustible materials. In
this case you must make corresponding changes to secure heat isolation of combustible parts. Safety measures
from the standpoint of the fi re protection according to EN 061008čl. 21:
www.combisteel.com
4