Preparation - Cembre B-TD270 Notice D'utilisation Et Entretien

Do not use the tool for purposes other than those intended by Cembre.
The operator should concentrate on the work being performed and be careful to maintain
balanced working position.
Work in a clean, uncluttered area. Keep persons away from immediate work area.
Inspect the blades before each use. Do not use damaged blades.
Damaged blades can break and cause injury or damage to the tool.
Before each use, verify the integrity of the tool; replace any worn, possibly damaged or missing
parts with original Cembre spares.
Wear eye protection. Metal chips can fly from blades when cutting.
The tool is unsuitable for continuous use and should be allowed to cool down following uninter-
rupted, successive cutting operations; for instance, having exhausted a fully charged battery in
one session, delay battery replacement for a few minutes.
Protect the tool from rain and moisture. Water will damage the tool and battery. Electro-hydraulic
tools should not be operated in pouring rain.
2. INSTRUCTIONS FOR USE
The part reference includes the following:
Hydraulic battery tool.
Li-Ion rechargeable battery (2 pcs).
Battery charger (model depends on the tool version).
Shoulder strap.
Canvas bag 030.
Allen keys to replace the blades.
USB cable (Ref. to § 5).

2.1) Preparation

When out of the trolley, the tool can be easily carried using either the handle or the shoulder strap
attached to ring (12) (Ref. to Fig. 4).
Before starting any work, check the battery charge (Ref. to § 2.6) and recharge if necessary,
following the instructions in the battery charger user manual.
To
replace the battery, remove it by pressing the release button (11) (Ref. to Fig. 1), then insert
the new battery, sliding it into the guides until it locks.
WARNING
6