Assembly; Loop Handle Installation; Handlebar Installation; Installing Debris Shield - Maruyama B42L Manuel Du Propriétaire/Utilisateur

Assembly

Loop Handle Installation

Screw (4)
Nut (4)
1. Place the loop handle and the bottom clamp
approximately 11 inches (28cm) from the end of
the stop switch/ throttle trigger assembly for an
initial handle position.
2. Install the four screws and nuts. Leave the screws
finger-tight.
3. Reposition the loop handle up or down the shaft
assembly to the most comfortable position, but no
closer than 9 inches (22.8cm) from the end of the
stop switch.
4. Tighten the screws and nuts.

Handlebar Installation

IMPORTANT: Be careful not to damage the throt-
tle cable and stop switch wires when you remove
the handlebars from the shipping carton.
1. Loosen the four screws on the top of the clamp bracket.
2. Insert the left and right handlebars into the clamp
bracket. Note that the handlebar with the throttle
trigger and stop switch goes on the right-hand side
of the Trimmer/Brushcutter.
Loop Handle
Shaft Assembly
Bottom Clamp
— US-10 —
3. Adjust the handlebar to the desired position, then
tighten the four screws.
Throttle Trigger and Stop Switch
Handlebar
Stop Switch Wires and
Throttle Cable
4. Clamp the throttle cable and the stop switch wires
as shown.

Installing Debris Shield

[B42L, B42]
WARNING
POTENTIAL HAZARD
• Foreign objects can be thrown by the
Trimmer/Brushcutter.
WHAT CAN HAPPEN
• Contact with thrown objects can cause
personal injury.
HOW TO AVOID THE HAZARD
• Never operate the Trimmer/Brushcutter
without the debris shield in place.
Screw (4)
Clamp Bracket