Assembly; Loop Handle Installation; Handlebar Installation - Maruyama B420L Manuel Du Propriétaire/De L'utilisateur

Assembly

Loop Handle Installation

Screw (4)
Nut (4)
Loop handle must be assembled gearcase side from
the arrow (A).
1. Place the loop handle and the bottom clamp on the
shaft assembly.
2. Install the four screws and nuts. Leave the screws
finger-tight.
3. Reposition the loop handle up or down the shaft
assembly to the most comfortable position, but
don't over to the arrow mark.
4. Tighten the screws and nuts.
(A)
Loop Handle
Shaft Assembly
Bottom Clamp
— US-10 —

Handlebar Installation

IMPORTANT: Be careful not to damage the throt-
tle cable and stop switch wires when you remove
the handlebars from the shipping carton.
1. Loosen the four screws on the top of the clamp bracket.
2. Insert the left and right handlebars into the clamp
bracket. Note that the handlebar with the throttle
trigger and stop switch goes on the right-hand side
of the Trimmer/Brushcutter.
3. Adjust the handlebar to the desired position, then
tighten the four screws.
Throttle Trigger and Stop Switch
Handlebar
Stop Switch Wires and
Throttle Cable
4. Clamp the throttle cable and the stop switch wires
as shown.
Screw (4)
Clamp Bracket