Maruyama B42L Manuel Du Propriétaire/Utilisateur page 19

WARNING
POTENTIAL HAZARD
• Without the shoulder harness/strap
installed, the Brushcutter blade can pro-
duce side thrust which can expose the
operator and bystanders to blade contact.
• If the Brushcutter is not correctly posi-
tioned on the operator's right side, the
blade can produce side thrust which can
expose the operator and bystanders to
blade contact.
WHAT CAN HAPPEN
• Contact with the Brushcutter blade can
cause severe personal injury.
HOW TO AVOID THE HAZARD
• Never operate the Brushcutter without
installing and using the shoulder har-
ness/ strap.
• Always operate the Brushcutter with the
unit on your right side.
Hearing Protection
Hand Holding Throttle
Grip, Fingers on
Throttle Trigger
4. The left hand should be holding the left-hand grip
with the fingers and thumb fully enclosed around
the grip.
5. Accelerate and hold the engine at cutting speed
before entering the material to be cut.
6. Always release the throttle trigger and allow the
engine to return to idle speed when not cutting.
7. Stop the Trimmer/ Brushcutter engine when
moving between work sites.
CAUTION
• Always wear gloves and protective cloth-
ing when operating the Trim mer/
Brushcutter.
Eye Protection
Hand holding - Left hand
Grip, and fingers and
thumb fully enclosed
around the grip
Cutting Attachment Near
and Parallel to Ground
— US-18 —
• If the Cutting attachment blade becomes jammed,
stop the engine immediately.
• Make certain all moving parts have stopped and
disconnect the spark plug before inspecting the
equipment for damage.
• Never use a Trimmer/Brushcutter that has chipped,
cracked or broken cutting attachment or shield.
[B42, B42A]
IMPORTANT: To detach the harness quickly
from the Trimmer/Brushcutter, push the red
button.
Red Button
[B42L]
IMPORTANT: To detach the strap quickly from
the Trimmer/Brushcutter, pull upward on the
red band.
Red Band
Pull
Hook
Ring
Push
Strap