Dimplex PLX 050E Instructions De Montage Et D'utilisation page 14

English
NOTE NOTE
Installation on wooden walls is permissible.
Wall mounting
CAUTION!
The original wall bracket supplied on the rear
CAUTION!
of the device must be used!
NOTE NOTE
Look out for electric cables or pipework in the wall
when drilling.
Remove the wall bracket from
the rear side of the device. To
do this, press both springs
down.
Drill the fastening holes.
Screw the wall bracket
securely to the wall.
Hook the device in the bottom slots of the wall
bracket.
Fold the device up and engage in the springs to
lock.
3. Electrical connection
The voltage specified on the type plate must match the
line voltage.
The cable must not be in contact with the casing.
It is recommended that a separate circuit be provided
for the power supply.
PLX 050E - PLX 200E
Insert the plug in the socket. The plug must always be
accessible in case of emergencies.
PLX 300E
The device must only be installed and repaired by a
qualified electrician in accordance with the applicable
safety regulations. Heating device must be earthed!
Connection may only take place on securely routed
cables!
A disconnecting device with a contact opening of at
least 3 mm at each pole (e.g. circuit breaker) must be
provided in the permanently installed wiring.
EN-3
4. Overload protector
For your safety, the heating device is equipped with an
overload protector. If the air circulation is interrupted
(e.g. due to the air grille being covered or closed), the
device switches off automatically.
In this case, the power supply to the heating device
should be disconnected for a few minutes (disconnect
the plug, switch off the fuse) to allow the device to cool
down sufficiently.
Before recommissioning the device, remove the
reasons for the overload protector being triggered.
5. Cleaning
The device must be disconnected from the mains and
allowed to cool down before cleaning and
maintenance. Clean the outside of the device using a
soft, damp cloth. Do not use scouring powder or
furniture polish as this may damage the surface. Dust
which gathers inside the device can be removed from
the outside using a vacuum cleaner.
6. Faults
If Err appears on the display, there is a fault.
Display Meaning
Err1 Temperature sen-
sor defect.
Err2 Window detection
operated.
Err3 Heating device
too hot.
Err4 Ambient tempera-
ture exceeded.
Err9 Loss of time.
Err10 Heating element
defective.
How to delete the error message
Press button ENTER for ten seconds. Display Err
disappears.
The heater is ready for operation.
If error recurs, notify the factory after-sales service.
1811/D
PLX 050E - PLX 300E
Measurements
Contact our service
Close window.
Delete error message.
If necessary deactivate
the function, see sec-
tion 11.6
See chapter 4.
Delete error message.
Notify the factory after-
sales service.
Delete error message.
Re-enter time.
Notify the factory after-
sales service.
www.dimplex.de/en