Navigating The Display - Steca GRID 2000+ Instructions D'installation Et De Service

4.9 Navigating the display
Button (A) Escape:

Use this button to return to the main menu from the individual menu

items and to exit the setup menu.
Buttons (B) and (C) Arrow buttons Up and Down:

Use these buttons to run through the individual menu items or to carry

out settings in the setup menu.
Button (D) Enter:

Use this button to go to another menu level or to confirm a setting in

the setup menu.
As soon as a voltage is present on the AC side of the inverter for the first time,
you must select the language desired. The following languages can be selected:
German, English, French, Spanish and Dutch. The following display then appears
in the selected language:
'Warning: country selection: only permitted once, see manual'
Press the Enter button to continue.
1

In this display the country can be selected. Use the arrow buttons to select
2

the country desired. Then press the Enter button to confirm your selection.
After you have selected the country, the setting is shown and you are asked
3

to confirm the setting. If you choose the wrong country you can press the
Escape button to return to the selection list. If the country chosen is cor-
rect, confirm the selection using the Enter button. The normal display now
appears.
It is possible to switch the inverter on and off by hand. The inverter is

switched off as standard when delivered. This setting can be changed in
menu 2-1 of the inverter.
Press the Enter button to continue.
4

Use the arrow buttons to go to menu  and press the Enter button once
5

again.
This is the display with which the inverter can be switched on and off. Press
6

the Enter button.
The current status is shown underneath the text. The inverter can

now be switched on and off by pressing the Enter button again. If the
inverter is switched on manually it can be some time before it becomes
activated. Then the inverter is fully installed.
40
EN
A
76.439 | 10.04
B
D
C