Steca GRID 2000+ Instructions D'installation Et De Service page 43

EN
1--5-1 Total energy
-1-1 Manual on/off
--1 Inverter a
-- Inverter b
--3 Inverter c
-3-1 Message 1
to to
-3-n message n
3-1-1 Grid voltage, frequency, electric-
ity
3--1 PV voltage
3-- PV current
3--3 PV output
3--4 Mains electricity
3--5 Primary bus voltage
3--6 Secondary bus voltage
3--7 Internal temperature
4-1 System
4- Inverter a
4-3 Inverter b
4-4 Inverter c
4-5 Display
4-6 RFM
5-1-1 Time
5-1--1 1
5-1-- 4
5-1-3 Date
5-1-4-1 Yyyy-mm-dd
to dd-mm-yyyy
5-1-4-3 mm-dd-yyyy
5--1-1 Always switched on
5--1- Always switched off
5--1-3 Energy-saving mode
76.439 | 10.04
The total energy that that has been produced
since the time of installation (individual read-
ings for master and slaves).
By pressing the Enter button, master & slaves
can be switched on and off at this menu item.
Shows the status of the master. Options: acti-
vated, standby, sleep, off
Shows the status of the 1st slave. Options:
activated, standby, sleep, off
Shows the status of the nd slave. Options:
activated, standby, sleep, off
Only applicable when there is a fault message.
The fault message is shown here.
Shows the current measured values for the grid
voltage, the electricity fed into the power grid
and the grid frequency.
Shows the DC voltage of both inputs for both
the master as well as the slaves.
Shows the DC current of both inputs for both
the master as well as the slaves.
Shows the DC output at both inputs for both
the master as well as the slaves.
Shows the electricity fed into the grid for both
the master as well as the slaves.
An internal voltage in the inverter. The value of
this voltage provides the technician with infor-
mation about the status of the inverter when
there is a fault.
An internal voltage in the inverter. The value of
this voltage provides the technician with infor-
mation about the status of the inverter when
there is a fault.
Shows the current inner temperature of the in-
verter for both the master as well as the slaves.
Shows the type, serial number and version
number of the relevant component.
Shows the type, serial number and version
number of the relevant component.
Shows the type, serial number and version
number of the relevant component.
Shows the type, serial number and version
number of the relevant component.
Shows the type, serial number and version
number of the relevant component.
Shows the type, serial number and version
number of the relevant component.
When the Enter button is pressed here, the
time starts to flash. It can be set by pressing
the arrow buttons. The setting is confirmed by
pressing the Enter button.
When the Enter button is pressed here, the time
is shown using the 1-hour clock, i.e. showing
AM/PM.
When the Enter button is pressed here, the time
is shown using the 4-hour clock.
When the Enter button is pressed here, the
date starts to flash. It can be set by pressing
the arrow buttons. The setting is confirmed by
pressing the Enter button.
By selecting the relevant entry the correspond-
ing format is specified for displaying the date.
By selecting this entry illumination of the display
is always switched on.
By selecting this entry illumination of the display
is always switched off.
By selecting this entry illumination of the display
is automatically switched on as soon as the
navigation buttons are pressed. After the but-
tons are pressed the display remains illuminated
for a certain length of time before the illumina-
tion automatically switches itself off.
43