Transmitter Controls; Adjusting The Dual Rates; Installing The Transmitter Batteries; Before Running Your Vehicle - Horizon Hobby LOSI 1969 CAMARO Manuel D'utilisation

EN

TRANSMITTER CONTROLS

7
6
5
3

ADJUSTING THE DUAL RATES

The transmitter allows you to adjust steering and throttle dual rates.
Steering Dual Rate
1. Power ON the transmitter.
2. Power ON the vehicle.
3. Turn the steering wheel fully left or right on the transmitter and hold that position.
4. To adjust the endpoints press the Steering Trim +/- button to increase or decrease the throw.
Throttle Dual Rate
1. Place the vehicle on a stand, and power ON the transmitter.
2. Power ON the vehicle.
3. Apply either forward or reverse throttle input on the transmitter and hold that position.
4. To adjust the endpoints press the Throttle Trim +/- button to increase or decrease throw.
NOTICE: Do not adjust the throttle dual rate while the vehicle is powered on and the wheels
are in contact with any surface. Adjusting the throttle dual rate may power the motor, which
could cause damage to property or personal injury.

BEFORE RUNNING YOUR VEHICLE

1. Check for free suspension movement. All suspension arms and steering components
should move freely. Any binds will cause the vehicle to handle poorly.
2. Charge a battery pack. Always charge the battery pack as per the battery and/or
charger manufacturers' instructions.
3. Set the transmitter steering trim. Follow the instructions to set the steering trim/subtrim
so that the vehicle drives straight with no input to the steering.
4. Perform a Control Direction Test.
4
8 9
4
1
2
1. Steering Wheel Controls direction (left/right) of the model
2. Throttle Trigger Controls speed and direction (forward/brake/reverse) of the model
3. ON/OFF Switch Turns the power ON/OFF
4. Throttle Trim/Dual Rate Adjusts the throttle trim/end points
5. Steering Trim/Dual Rate Adjusts the steering trim/end points
6. CH 3
7. Indicator Lights
- Solid blue light—Indicates radio connectivity and adequate battery power
- Flashing blue light—Indicates the battery voltage is critically low. Replace batteries
8. REV Reverses the steering wheel and throttle functions
9. Antenna Transmits the signal to the model

INSTALLING THE TRANSMITTER BATTERIES

Assemble
1. On the top transmitter portion,
press the rear button.
2. Slide the transmitter handle into the
track.
Install the batteries in the handle
This transmitter requires 4 AAA batteries.
1. Remove the battery cover from the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.
CAUTION: Never remove the transmitter batteries
while the model is powered ON. Loss of model
control, damage, or injury may occur.
CAUTION: If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable
batteries may cause the batteries to burst, resulting in injury to
persons and/or damage to property.
CAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of
used batteries according to national regulations.

DRIVING PRECAUTIONS

• Maintain sight of the vehicle at all times.
• Routinely inspect the vehicle for loose wheel hardware.
• Routinely inspect the steering assembly for any loose hardware. Driving the vehicle
off-road can cause fasteners to loosen over time.
• Do not drive the vehicle in tall grass. Doing so can damage the vehicle or electronics.
• Stop driving the vehicle when you notice a lack of power. Driving the vehicle when
the battery is discharged can cause the receiver to power off. If the receiver loses power,
you will lose control of the vehicle. Damage due to an over-discharged Li-Po battery is
not covered under warranty.
CAUTION: Do not discharge a Li-Po battery below 3V per cell. Batteries
discharged to a voltage lower than the lowest approved voltage may become
damaged, resulting in loss of performance and potential fire when batteries are charged.
• Do not apply forward or reverse throttle if the vehicle is stuck.
Applying throttle in this instance can damage the motor or ESC.
• After driving the vehicle, allow the electronics to cool before driving the vehicle again.
IMPORTANT: Keep wires away from all moving parts.
'69 CAMARO 1:10 4WD RTR • INSTRUCTION MANUAL
Disassemble
1. On the top transmitter portion, press the
rear button.
2. Slide the transmitter handle out of the
track.