Cycle Operating; Preparation - Alliance Bio Expertise MEDIAWEL 10 Manuel D'utilisation

Cycle operating



Preparation


Sequence
of
operations
Connect the water supply hose,
1 Connect the drain hose,
Open the water tap
Connect the power cable, enable the system's circuit
2
breaker,
3 Make sure the drain plug is securely in place
Fill the hot-water bath with 2.5L of water (Water level just
4
under the 2
Put the bucket into the vessel, a bucket lock orientated at
10
5 Go the bucket down to the bottom and turn in the clockwise
direction until It is locked in the vessel.
PAY ATTENTION NOT TO HIT THE TEMPERATURE PROBE
Place the stirrer on the axis of the bucket after après s'être
6
assurer de la présence de la rondelle de glisse sur l'axe,
7 Replace the carded cotton in the cage (Before each cycle)
Switch on the device by pressing the main switch
8
Pour 1/3 of demineralized water of the total volume to be
9
prepared in the vessel
Slowly pour the powder, avoiding putting it on the wall and
10
on the blades of the stirrer
11 Start the agitator at speed 5
Opération
nd turn of the heating component),
74
Symbol
Clip