Festo FSSC−12 Notice D'utilisation page 18

Commander
1
START : Input for an external transducer
IN
for starting (chapter 8)
2
0−POSITION : Input for direct group base
IN
position. All external transducers are linked
via and−circuits.
3
END : Input for an external transducer for
IN
stopping after cycle−end in continuous
cycle pre−select.
4
L : Input for an external transducer for
IN
resetting (chapter 8)
Fig. 2: Connections
The non−labelled connections are the interfaces to the sequence controller. These
are connected to the Festo FSS−12−C Quickstepper in accordance with Fig. 3.
18
1
2
7 6
5
STOP : Input for an external transducer for
IN
stopping in the cycle (chapter 8)
6
P : Input for operating pressure
IN
7
NOT AUS (EMERGENCY STOP): Input for an
external EMERGENCY−STOP transducer. If
no signal is applied, or if operating pres
sure falls, the outputs A1 ... A12 of the
Festo FSS−12−C Quickstepper are blocked.
This also applies if an external EMERG
ENCY−STOP impact switch is unlocked.
3
4
5
Festo FSSC−12 0410a English