Replacing The Sanding Pad [3] - Festool ETS EC 150/3 A EQ Guide D'utilisation

ton [1-1].

Hold down the ON/OFF button [1-1].
Motor switches off, power tool beeps once.

Turn speed control [1-2] to level 1 and level 6.
Power tool beeps three times.

Release ON/OFF button [1-1].
Extractor signal is activated.
 To deactivate the extractor signal repeat the
above-mentioned procedure, power tool beeps
twice.

Replacing the sanding pad [3]

An optimal work result can only be achieved
using original accessories and consumables.
The use of non-original accessories or con-
sumables invalidates the right to claim under war-
ranty.
Warning! Do not perform any structural
changes in the open interior space of the ma-
chine when the sanding pad is dismantled.
Health risk: Fitting sanding pads of incorrect
size causes excessive vibration of the ma-
chine.
Permanent light: Extractor
hose is connected
Flashing light: No extractor
hose connected, power tool
cannot be switched on.
No light: Extractor signal is
not active.
3
Tuned to the surface being processed, the machine
can be equipped with three sanding pads of differ-
ent hardnesses.
Hard: Coarse and fine sanding on surfaces. Sand-
ing edges.
Soft: Universal for coarse and fine sanding, for flat
and convex surfaces.
Extra-soft: Fine sanding of moulded parts, arches,
radii. Do not use on edges.
11