Jøtul C 24 Manuel D'installation Et D'utilisation page 10

EnGLIsH
Use
The fan unit improves air circulation around the burn chamber
and heat distribution in the room.
The fan unit has two operating modes: Auto and Manual. These
are selected using the slide switch on the control panel.
Position A = Auto. The fan starts at the selected speed when the
burn chamber starts to generate heat. When the burn cham-
ber has cooled down again, the fan stops automatically.
Setpoint
Start: 50 C
o
Stop: 35 C
o
Position M = Manual: The fan runs at the selected speed.
The speed of the fan is controlled using the dial on the control
panel. This has four position.
Fig 10
0: The fan is off regardless of the operating mode
selected.
I: Lowest speed (1000 rpm ± 7,5% = 130m
II: Medium speed (1300 rpm ± 7,5% = 165 m
III: Highest speed (1950 rpm ± 7,5% = 250m
Fuse: 315mA
250V
10
/h ± 7,5%)
3
/h ± 7,5%)
3
/h ± 7,5%)
3
L
N PE PE
L1 L2 L3
N
man
N
aut