Jøtul C 24 Manuel D'installation Et D'utilisation page 9

Fig 7
A
Lukket/Closed
• Close the inlet air damper if it is open (Fig 7A).
• Remove the heat shield (Fig 6B).
Bild 8
B
A
• Unscrew the screw holding the side wall inside the inlet air
chamber (Fig 8A).
• Remove the inlet air chamber side wall (Fig 8B).
• Push out the cable slot (Fig 2A).
• Thread the cable with the female connector through the
slot in the fan cover.
• Secure the cable to the bracket on the bottom of the fan
cover (make sure there is enough cable for the connector to
fit) (Fig. 2B).
Fig 9
• Push the fan unit in against the rear wall (Fig 9A).
• Connect the male and female connectors (Fig. 9B).
WARNING! The female connector cable must not yet be
Åpen/Open
connected to an electrical source.
• Push the fan unit in sideways so that the screw hole over
the fan on the left-hand side fits with the threaded hole
for the screw that was holding the side wall in place inside
the inlet air chamber (Fig 9C). Be careful not to knock the
gasket out of position.
• Secure the fan unit using the same screw that was holding
the side wall (Fig 9D).
• The fan unit can now be connected to electricity and
tested. NB: Installation must be carried out by a qualified
electrician in conformance with local regulations.
• Refit the heat shield and tighten the screw in the middle of
the shield (Fig 6A-B).
• Open the inlet air damper if there is no outside air
connection (Fig 7A).
• Insert the front piece with the ash base. Push it firmly
against the rear (Fig 5B).
• Insert the back burn plate (fig 4C).
• Screw two screws into the back burn plate (Fig. 4A) and
two screws on the rear of the front piece (Fig. 5A). Tighten
well.
• Insert the baffle (Fig. 4B). The baffle should be resting on
the back burn plate and hanging on a screw on the left-
hand side.
• Insert the side burn plates (Fig 3).
• Refit the ash pan and fire grate if these have been removed.
C B A D
EnGLIsH
9