dji MAVIC PRO Manuel De L'utilisateur page 53

Masquer les pouces Voir aussi pour MAVIC PRO:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. Re-calibrate the aircraft if the aircraft status indicators blink red.
If the Aircraft Status Indicator blinks red and yellow after the calibration procedure, move your
aircraft to a different location and try again.
Calibrate the compass before each flight. Launch the DJI GO app and follow the on-screen
instructions to calibrate the compass. DO NOT calibrate the compass near metal objects such
as a metal bridge, cars, scaffolding.
If the aircraft status indicators is blinking red and yellow alternately after placing the aircraft on
the ground, the compass has detected magnetic interference. Change your location.
When to Recalibrate
1.When compass data is abnormal and the Aircraft Status Indicator is blinking green and yellow.
2.When flying in a new location or in a location that is different from the most recent flight.
3.When the mechanical or physical structure of the Mavic Pro has been changed.
4.When severe drifting occurs in flight, i.e. Mavic Pro does not fly in straight line.
Auto Takeoff and Auto Landing
Auto Takeoff
Use auto takeoff only if the Aircraft Status Indicators are blinking green. Follow the steps below to use the
auto takeoff feature:
1. Launch the DJI GO app, and enter "Camera" page.
2. Ensure the aircraft is in P- mode.
3. Complete all steps on the pre-flight checklist.
4. Tap"
", and confirm that conditions are safe for flight. Slide the icon to confirm and takeoff.
5. Aircraft takes off and hovers at (1.2 meters) above ground.
Aircraft Status Indicator blinks rapidly when it is using the Vision Position System for stabilization.
The aircraft will automatically hover below 3 meters. It is recommended to wait until there is
sufficient GPS lock before using the Auto Take-off feature.
Auto-Landing
Use auto-landing only if the Aircraft Status Indicators are blinking green. Follow the steps below to use
the auto-landing feature:
1. Ensure the aircraft is in P- mode.
2. Check the landing area condition before tapping "
instructions.
Mavic Pro User Manual
", to begin landing. Then follow the on-screen
©
2016 DJI. All Rights Reserved.
53

Publicité

Table des Matières
loading

Table des Matières