Lubrication - Dovre Vintage 50 Mode D'emploi

Lubrication

Although cast-iron is slight self-lubricating, you will
still have to lubricate moving parts frequently.
Lubricate the moving parts (such as hinge pins,
latches and air slides) with heat resistant grease
that is available in the specialist trade.
Re-adjusting the door lock
1. Loosen the hexagon nut (1) slightly.
2. Screw the locking cam (2) in or out with the help of
a screwdriver.
3. Re-tighten the locking nut.
Readjusting the hinge
1. Loosen the screws (2) and (3) slightly.
2. Screw setscrew (1) in if the door must be raised
and out if the door must be lowered.
3. Retighten the screws (2) and (3) firmly.
Subject to change because of technical improvements
Maintenance
Removing the glass pane
1. Loosen the 2xM5 nuts on the top only.
2. Tilt the pane forwards and lift the pane out of the
bottom fixing lips.
Before replacing:
1. Place the glass pane together with the two glass
fixings.
2. Tighten the 2xM5 nuts.
17