Cleaning Glass; Lubrication; Removing The Fan - Dovre 2576CBSC Installation Et Mode D'emploi

Cleaning glass

Dirt clings less easily to well-cleaned glass. Proceed
as follows:
1. Remove dust and loose soot with a dry cloth.
2. Clean the glass with stove window cleaner:
a. Apply stove window cleaner to a kitchen
sponge, rub down the entire glass surface and
give the cleaning agent time to react.
b. Remove the dirt with a moist cloth or kitchen
tissue.
3. Clean the glass again with a normal glass cleaning
product.
4. Rub the glass clean with a dry cloth or kitchen
tissue.
Do not use abrasive or aggressive products to
clean the glass.
Wear household gloves to protect your hands.
If the glass in the appliance is broken or
cracked, it must be replaced before you can
use the appliance again.
Make sure that no stove window cleaner runs
between the glass and the cast-iron door.

Lubrication

Although cast-iron is slightly self-lubricating, you will
still have to lubricate moving parts frequently.
Lubricate the moving parts (such as guide
systems,hinge pins, latches and air slides) with
heat resistant grease that is available in the
specialist trade.

Removing the fan

It is advisable to inspect the fan of the stove regularly
for dust and dirt. Dust and dirt hinder the proper
operation of the fan. The fan is easy to remove from
the stove. Proceed as follows to remove the fan:
1. Disconnect the fan from the mains.
2. Open the door of the stove.
Subject to change because of technical improvements
3. Remove the fireproof inner plates; see the
paragraph "Removing fireproof inner plates" in the
chapter "Installation".
4. Take the fire plate out of the appliance.
5. Loosen the three M6 screws (A) and remove the
ventilator cover; see next figure.
6. Carefully remove the insulating plate and
disconnect the wiring.
7. The fan can now be reached. Tilt the fan out from
the back.
The fan is held in place with Velcro tape.
8. Remove the fan from the appliance through the
door.
9. Close the door of the stove.
Note: To put back the fan, follow the steps set out
above in the reverse order.
Touching up the finish
Small areas of damaged paint finish can be touched
up with a spraying can of special heat-resistant paint
A
09.20015.013
09.20017.032
17