6 Putting into operation
3
1
3-pole flange plug
Fig. 6
Functional diagram (View from PINs side of the connector)
6 Putting into operation
EN - 12
3
2
1
2
Micro switch triggered
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance,
servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close off the compressed air and gas supplies.
• Disconnect the mains plug.
NOTICE
• Please take note of the following instructions:
2 Safety on page EN-4
• The system may only be put into operation by qualified personnel
(in Germany see TRBS 1203).
1
M8x1
M9x0.5
1
3
2
2
3
1
2
3
Micro switch in resting position
BAL.0324.0 • 2017-02-01
CAT3
Signal
24 V
GND