Putting Out Of Operation; Maintenance And Cleaning - Abicor Binzel CAT3 Mode D'emploi

8 Putting out of operation

8 Putting out of operation

9 Maintenance and cleaning

EN - 16
As the iSTM ECO is integrated into the torch's welding process, the operating
steps are performed after the respective torch has been put into operation.
Putting out of operation depends on the respective welding torch.
NOTICE
• When putting the system out of operation, ensure that the procedures for
switching off each of the welding system components are observed.
Scheduled maintenance and cleaning are prerequisites for a long service life
and trouble-free operation. During such activities, observe the following:
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance,
servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close the compressed air supply.
• Close the gas supply.
• Switch off the entire welding system.
• Disconnect all electrical connections.
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and
damage.
• Replace any damaged, deformed or worn parts.
NOTICE
• Maintenance and cleaning work may only be carried out by qualified
personnel (in Germany see TRBS 1203).
• Always wear your personal protective equipment when performing
maintenance and cleaning work.
CAT3
BAL.0324.0 • 2017-02-01