Publicité
Test Air Shutter Movement
Locate the air shutter lever on the left of the module
plate under the receiver. Pull and push it to ensure it is
moving freely.
Replace the Pilot Injector
1. Remove the pilot shield (2 screws).
2. Remove the pilot hood by releasing the U-clip and
pulling up on the hood. The U-clip should not be
removed.
Pilot hood
U-clip
3. Unscrew the pilot injector using an Allen key. Dis-
card the old pilot injector.
4. Replace with the appropriate pilot injector—see
Specifi cations table on page 1 (the pilot injector
number is stamped on the barrel). Screw in the new
injector.
4
5. Refi t the pilot hood by
pushing down on it, mat-
ing its notch and key at the
base. Ensure that it snaps
into position.
6. Install the pilot shield
supplied with the kit if
diff erent than the one that
was installed (2 screws).
Notch
Key
Publicité
