Publicité
Replace Burner Injector
1. Undo burner supports (4 screws).
2. Unscrew the nut at the end of the burner fuel
supply line, and lift the burner and supports out of
the fi replace (complete with injector elbow at-
tached).
Injector elbow
Nut
3. Unscrew and disengage the injector elbow. Be
aware that four pieces sit between the elbow and
the burner, do not drop them.
4. Exchange injector elbow from kit, verifying the new
injector before you install—see Specifi cations table
on page 1. The injector number is stamped on the
corner of the elbow.
5. Exchange the air shutter from kit as its shape is dif-
ferent for each fuel.
6. Reassemble the burner, putting the fl at washer, ten-
sion washer, air shutter, and anti-fl ashback shield
back in order as shown below. Reconnect injector
elbow to the burner, as tightly as possible while
leaving the elbow connection angled toward the
fuel supply line. Do not over tighten.
Tension washer
Natural
different shape
Flat washer
(wavy)
Air shutter
for each fuel
Anti-flashback
shield
7. Replace the burner. The stem on the end of the air
shutter must mate with the vertical slot in the link
bracket. No nut is required.
8. Connect the fuel supply line and tighten the nut. The
burner angle may need adjusting to better align in-
jector threads with the fuel line nut while tightening.
9. Reattach the burner supports (4 screws).
10. Air shutter stopper, if equipped.
This part is no longer necessary. If the appliance has
an air shutter stopper, remove the 2 screws retain-
ing it, discard it and reinstall the 2 screws to plug the
holes. This part is no longer used
If appliance equipped
with air shutter
stopper, remove
and discard. Re-use
screws to plug holes.
Air shutter stopper
removed
Propane
3
Publicité
