Technical Specifications - BS Charger BS60 Manuel D'utilisation

Table des Matières

Les langues disponibles

TEMPERATURE & SAFETY PROTECTION

•

INTERNAL OVERHEAT PROTECTION: the charger has a built-in overheat and an overload protection. This protects the charger

from being damaged if overheated or overloaded and will automatically decrease the charging current. Once the unit's internal

temperature decreases to a safe level, the charger will resume normal charging.

•

SAFETY TIMER PROTECTION: the charger has safety timers for every stage. If the battery voltage doesn't reach a certain vol-

tage within a certain amount of time, the unit will stop charging as it's highly likely that you're attempting to charge a severely

discharged or heavily sulphated battery. If any of the stages time out, the charger will immediately stop charging in order to

protect the battery. This will be indicated with the ERROR LED flashing slowly.

•

REVERSE POLARITY: the charger has a reverse polarity protection. If the charger output leads are connected with a reverse po-

larity, the ERROR LED will light on and the charger will be disabled. Simply unplug the charger from AC power and then connect

the output leads to the correct polarity.

•

SHORT CIRCUIT PROTECTION: the charger will automatically turn off if the output leads are short circuited and the ERROR LED will

light on. This prevents the charger from being damaged if the positive and negative crocodile clips or the optional ring terminals

accidently touch each other while the charger is turned on.

•

ECO MODE: this battery charger has a built in ultra-low power consumption circuit. If AC power is connected and the battery is

disconnected, after 10 seconds the charger will automatically go into an ECO mode. During this mode the power drawn is less

than 0.36W which totals 0.01kWh per day power consumption. If AC power is connected and the battery is connected, once the

battery is fully charged and during the long term maintenance stage, the total power consumption is around 0.03kWh per day.

Both the selected charge rate and battery type LED's will flash GREEN to indicate ECO mode.

BATTERY TYPES & CAPACITY

Suits 12V conventional lead acid batteries (VRLA) AGM, Calcium, Gel & Wet. The Ah (Ampere Hours) capacities shown below are to

be used as a general guide only. Some batteries may be able to handle a higher charge current. Refer to the battery manufacturer's

specifications and recommendations for your charging requirements.

Charge Rate:

charging

3-20Ah

Maintaining

<100Ah

ELECTRICAL PARTS & ACCESSORIES

AC Power Cord

1.8m with 2 Pins Plug

DC Output Lead

1.2m with quick connect

Charging Leads

Quick connect 60cm with Crocodile Clips + Quick connect 60cm with fused ring terminals