Environmental Characteristics; Technical Specifications - BS Charger BS 10 Manuel D'instruction

BATTERY TYPES & CAPACITY
• Suits all Lead Acid Type Batteries. (Conventional, AGM & Gel).
•
Suits for Lithium (LiFePO4) battery.
•
Battery Capacity:
Charge rate
1Amp
ELECTRICAL PARTS
Delivered with:
•
Input Cord: 2 pin VDE plug wall mounting type.
•
Output Cord: 122cm with quick connector.
• Extend Cord: 61cm with battery ring terminal / battery clips.

ENVIRONMENTAL CHARACTERISTICS

•
Operating Temperature: 0 to 40° C.
•
Storage Temperature: -25 to 85°C.
• Operating Humidity Range: 0 to 90% RH.
• Cooling: Natural cooling.

TECHNICAL SPECIFICATIONS

AC input
Input Frequency
Rated output
Suit for battery type
Power Efficiency
Charging stage
Start voltage
Charging voltage
Float voltage – Lead acid battery
Maintenance voltage – Lead acid battery
IP class
Voltages for 12V mode, x 1/2 for 6V mode
OPERATING INSTRUCTIONS
STEP 1 - Pre-charge Check & electrolyte level check
• Check the Battery Electrolyte level for Lead Acid battery (Not required on Sealed & Maintenance Free Batteries). If necessary,
remove the vent caps and add distilled water so the levels are halfway between the upper and lower fill lines.
•
Check the 6/12V Switch on the charger and make sure it's on the correct voltage.
STEP 2 - Connecting the battery charger to your battery
• Connect the Red lead from the charger to the positive (+) battery terminal.
•
Connect the Black lead from the charger to the negative (-) battery terminal.
| www.bs-battery.com
Battery capacity - charging
2-20Ah
90~265Vac
50/60Hz
6/12V 1Amp
Compatible for Lead Acid or Lithium (LiFePO4) battery
>80%
Multiple – 9 stages
2.0V for 6V mode; 8V for 12V mode
14.4V
13.6V
13.0 – 13.8V
IP22
Battery capacity - maintaining
2-40Ah
4