baby walker, push the upper part of the structure upwards
until it clicks into its locked position. To lower the height
move the knob located below the upper part of the struc-
ture and turn it counter-clockwise (fig. 12), push the knob
up, accompany the upper part to the desired position (fig.
13). Upon release of the pin, the structure is automatically
locked. The height can be adjusted to three different po-
sitions.
WARNING: Before putting the child in the baby walk-
er, make sure that the knob is properly locked in place as
shown in figure 14.
10. To close the baby walker, turn the knob located under
the top part counter-clockwise and push it upwards. Then
lower the top part until completely closed (fig. 15).
WARNING: Do not close the baby walker with the child
inside.
BAR SUPPORT
To properly use the bar support, starting from the rest po-
sition (resting on the upper part of the structure), do the
following:
- Pull the bar support out of the baby walker in the direction
of the arrow at the end of the intersections until it stops;
grab the bar in the middle part (fig. 16);
- Then rotate the bar support upwards, until it clicks locked
(fig. 17).
To take down the bar support and to bring it back in its
original position, follow these steps:
- Pull the bar support out of the baby walker in the direction
of the arrow at the end of the intersections until it stops,
holding it in the middle part (fig. 18);
- Then turn the bar support downwards (fig. 19), bringing it
back to the rest position (fig. 20).
WARNING: Keep your child away from all moving parts
whilst you adjust the baby walker.
WARNING: Do not move or lift the baby walker grabbing it
at the bar support or at features on it.
WARNING: Do not lean on the bar support.
Made in China
WARRANTY
The product is guaranteed against any conformity defect in
normal conditions of use as provided for by the instructions
for use. The warranty shall not therefore apply in the case
of damages caused by improper use, wear or accidental
events. For the duration of warranty on conformity defects
please refer to the specific provisions of national laws appli-
cable in the country of purchase, where provided.
11