Stihl MM 55 Notice D'emploi page 12

English
Symbol on slide control
7 h – stop symbol and arrow. To stop
the engine, push the slide control in
the direction of the arrow on the stop
symbol (h) to STOP-0.
Starting
Swing bike handle into working
N
position – see "Adjusting the Bike
Handle"
Press down the trigger lockout lever
N
and squeeze the throttle trigger
and hold them in that position.
N
Move the slide control to START
N
and hold it there.
Now release the throttle trigger,
N
slide control and trigger lockout in
that order. This is the starting
throttle position.
8
9
Set the choke lever (8) to
N
10
All manuals and user guides at all-guides.com
g if the engine is cold
e for warm start – also use this posi-
tion if the engine has been running
but is still cold.
Press the manual fuel pump
N
bulb (9) at least five times – even if
the bulb is filled with fuel.
Cranking
Retract the wheels, if fitted.
N
Put the unit on the ground: It must
N
rest securely on the engine flange
and the support on the frame.
Check that the MultiTool is not
touching the ground or any other
obstacles – see also "Starting /
Stopping the Engine" in the
MultiTool instruction manual.
Make sure you have secure footing
N
– as shown. To reduce the risk of
injury from contact with rotating
attachments, always stand to the
side of the power tool.
With your left hand on the carrying
N
handle, press the unit firmly against
the ground.
NOTICE
Do not stand or kneel on the drive tube.
Hold the starter grip with your right
N
hand.
Version without Easy2Start
Pull the starter grip slowly until you
N
feel it engage and then give it a brisk
strong pull.
MM 55, MM 55 C