Publicité
All manuals and user guides at all-guides.com
Load UP
At the beginning of the charging process, the current acquires a high value which
slowly and gradually decreases until it becomes very low as the battery is being
charged.
When the battery is under charge, it may be noticed that the liquid held
inside it begins to boil.
It is better not to prolong the charge excessively, so as not to overheat the
elements and avoid oxidations of the plates. This will help to maintain the battery
in good condition. This is not valid for the models with electronic protection (76005
and 76006); these models stop automatically when the battery is charged.
6.0 ADJUSTMENT OF THE CHARGING CURRENT
Model 7-12-16-20-30:
With the proper multi-position regulator it is possible to increase or decrease the
charging current and, consequently, the speed at which the battery is charged.
In order to prolong the battery life span, it is advisable to charge it slowly, with a
charging current indicated by the instrument, comprises between 1/10 and 1/5 of
the capacity in Ah of the accumulator. Start the charge with the adjusting
commutator preferably on position "1".
The ampmeter shows the current required at that moment by the battery. When
the index of the ampmeter is nearing zero, increase by one step the adjusting
commutator. Proceed in this way for the next positions (when they are present)
until the charge is complete.
Wenn the battery is charged, it is important to stop the machine as soon as
possible, because otherwise the battery charger will keep on charging and
the battery may be damaged.
Model 20elek.-30elek.:
On position "automatic" the battery charger charges fully automatically and stops
automatically as soon as the battery is charged.
On position "Min." the battery charger charges a minimum current and on position
"Max." a maximum current.
On both positions "Min." of "Max." the machine will keep on charging and
has to be stopped as soon as the battery is charged.
Model 35/250 with starter:
On position "snail" the machine charges a minumum current and on position
"hare" a maximum current.
On both positions the machine will keep on charging and has to be stopped
as soon as the battery is charged.
On position "start" the vehicle can be started (see also point 9.1).
18
Publicité
