Publicité
W IRI NG CO NNECTIO N
• Connect the appropriate wires from the controller to your fan and then connect the wires
from the controller to your ceiling connections.
• Don't forget to connect the ceiling earth wire to the fan.
• Connect your fan wiring as shown in the diagram below:
CEILING
Grounding
N
Neutral N (White
L
Line L (Black)
CEILING
Grounding
N
Neutral N (White
L
Line L (Black)
FAN S U SP E NSI O N
1. Hang the motor housing on the mounting bracket. Rotate the fan so that the notch in the
ball engages the ridge of the mounting bracket.
2. Place the remote control receiver into the slot of the mounting bracket as shown in the figure.
3. Drive two screws in the middle position into opposite holes until there is approximately
5mm between the screw head and the edge of the mounting plate. Don't forget to place
washers between the screw head and the mounting bracket.
4. Slide the canopy onto the mounting bracket and align the locking slots with the two in-
stalled screws.
5. Turn the finial and tighten the screws. Install the two remaining mounting screws into the
other two holes in the canopy and tighten securely.
6. Once the electrical installation has been checked and completed, push the canopy up-
wards until the ceiling support and all the connection cables are covered. Match the
screws by lining up the holes in the canopy with the side holes in the bracket.
12
E NGL I SH
Grounding (Yellow/Green)
Driver
Fan N (Blue)
Fan L (Black)
Antena
Grounding (Yellow/Green)
Driver
Light N (White)
Light L (Blue)
Motor L (Black)
Antena
*Only for the model WITHOUT LIGHT
Fan N (Blue)
Fan L (Black)
*Only for the model WITH LIGHT
Light N (White)
Light L (Blue)
Motor L (Black)
Publicité
