Publicité
Install the handle support (item 1) on the stopper plate
(item 2) and secure with the same bolts (item 3) and
nuts (item 4) that you have removed.
Tighten firmly.
Install the plastic grommet (item 5) in the handle
support.
Hook the hoses (item 1) in the hook (item 2).
Remove the dust caps (item 3) and connect the hoses
into the quick couplers (item 4) (bottom section) of the
hydraulic valve on the tractor.
NOTE: In order to make sure that the hoses are well
installed, pull the hydraulic lift arm towards you, the
attachment must lift at least 4'' off the ground. If this
is not the case, reverse the hoses.
WARNING
TO
PREVENT
INJURIES
TRACTION WHEN USING THE ATTACHMENT:
-Rear counterweight of 150 lbs. minimum is
required to counterbalance attachment's weight.
-Tractor manufacturer approved tire chains are
required.
-Do not operate on a slope greater than 10°.
-When dismounting the attachment remove rear
counterweights.
ASSEMBLY
AND
FOR
MORE
6
Install the handle support
Connect the hoses
Publicité
