Publicité
ROTARY BROOM INSTALLATION:
Refer to rotary broom owner's manual, parts breakdown
section for their identification.
WARNING
FOR YOUR SECURITY:
Read rotary broom owner's manual for safety
precautions and rules.
Follow the assembly and operation instructions.
WARNING
TO PREVENT INJURIES:
Park the machine on a flat surface.
Disengage the P.T. O.
Lower the attachment to the ground.
Apply parking brake.
Stop the motor and remove the ignition key.
Wait until all moving parts have stopped before
leaving the driver's seat.
Install the male section of the driveline into the rotary
broom's driveline by aligning the stamped mark (item 2)
(located between the splines at the end of the shaft) with
the large groove (item 1) in the hollow tube of the rotary
broom's shaft.
NOTE: Only one position allows the shafts to be
inserted one into the other.
Install the extension guard (item 1) on the rotary broom's
chain guard with the height adjustment bolt (item 2) (1/4
x 1'' hex bolt) and a nut on the top and a nut
underneath.
Secure in place with two 1/4 x 1/2'' hex bolts (item 3)
and flange nuts.
Tighten firmly.
ASSEMBLY
16
Install the driveline sections
Install the extension guard
Publicité
